Unusual cover for a square floor pillow

Send

How nice to relax with a cup of fragrant tea or coffee, sitting in a comfortable armchair, and put tired legs on a beautiful decorative pillow. They say that it is not only convenient, but also very useful!

To make the floor cushion last for as long as possible and be easy to move behind you, sew several square covers for it with a carrying handle and a comfortable push-button zipper.

You will need:

✽ cotton jacquard fabric 1.30 m wide 140 cm;

✽ thread for sewing;

✽ detachable zipper 60 cm long;

✽ belt tape for the handle;

✽ spider web with a cord for edging;

✽ chalk pencil;

✽ tailor pins;

✽ ruler for patchwork;

✽ scissors;

✽ centimeter tape;

✽ scale ruler;

✽ ironed gasket G 770;

✽ volumenfliz P 140.

All sizes on the pattern diagram are given in centimeters.

Cutting:

a) upper and lower parts: 2x from fabric, 2x from volumenfliz P 140;

b) wide side part: 3x from fabric and 3x from G770 gasket;

c) narrow side part (for inserting a zipper): 2x of fabric, 2x of G 770 gasket.

Step 1

Press the volumeflyz to the upper and lower parts (a) from the wrong side and overcast the parts on the overlock.

Step 2

Put 9 marks, as in the picture, and make marking crosses with a narrow zigzag line.

Step 3

Press the G 770 gasket (b - 3x, c - 2x) to all side parts from the wrong side.

Step 4

Stitch the zipper straps on both narrow side parts to close the spirals.

Close the zipper.

Step 5

Press both ends of the 38 cm belt to the wrong side 4 cm and pin it to one of the wide side parts (b) in the middle.

Stitch both ends of the tape, laying the lines with a square and a cross on the cross, as in the figure.

Step 6

Stitch all side parts on the short sides into the ring.

Overlock and iron the seam allowances.

Overlap longitudinal allowances.

Step 7

Cut oblique inks 5.5 cm wide and sew them in two strips 2.40 m long.

Iron a spider web with a cord for each edging for each edging.

Step 8

Pin each edge and grind along the perimeter to the upper and lower parts of the cover (put the ends of the piping one on top of the other), while the thickened portion of the piping lies on the part, and the open sections are aligned with the sections of the cover part.