Collar processing with stand

Send

This type of collar is also called a shirt collar. He always has a stand, which remains unchanged, but the collar can be delayed to the seam of the stitching of the rack or raised up.

A stand-up collar borrowed from shirts is often used in dresses, blouses, sleeveless tops and tunics.

Stand collar can be one-piece with a collar, or cut separately.

Usually at the shirt collar, one piece of the collar (bottom) and both parts of the stand are reinforced with a gasket. But depending on the specific model and fabric, duplication of details may be different.

The stand of the collar always reaches the edge of the bead / bar.

The main types of collars

How to properly process a collar with a stand, consider the example of a dress, model 113 from Burda 3/2018:

Special offer

Shirt dress

Magazine: Burda 3/2018 Pattern: 113 Sizes: 34 - 44 A game with the direction of the pattern, a flying skirt, a drapery on the chest resembling a bustier ... Dress shirt ... 200 р. 99 р. Add to cart Game with the direction of the pattern, flying skirt, drapery on the chest, reminiscent of a bustier ... Dress shirt ...

Step 1

Cut out the details of the collar and stand collar.

Step 2

Duplicate the bottom part of the collar and one part of the stand with a gasket - press the non-woven fabric to the wrong side of the parts.

Step 3

Knock down the collar parts with the front sides, grind the outer sections. Cut the seam allowances close to the line, at the corners - obliquely.

Step 4

Turn the collar, iron and stitch to the edge.

How to carve seam allowances

Step 5

Iron in the cut-in allowance for the collar stand details not duplicated by laying on the wrong side. Pin this part of the stand to the collar from the side by a duplicated gasket of the part, duplicated by the gasket the part of the stand of the collar pin on the other side of the collar.

Step 6

Stitch the collar stand parts while securing the collar. Cut the seam allowances close to the stitch, notch.

Step 7. Stitch the collar

Turn the stand of the collar, sweep the edges and iron.

Duplicate the collar stand detail duplicated by the gasket to the neckline with the front side to the front side, aligning the transverse marks with the shoulder marks on the yoke.