Throat processing

The perfect neck? Who does not want this! Slices of the neck and armholes can be “cleaned” with a grinder. Secrets and secrets to help you perform this treatment simply and with pleasure!

The internal cut of the linings exactly repeats the shape of the processed cut of the neck or armhole. If you make adjustments to the pattern of the product during fitting and sewing, then you should not forget to adjust the same areas on the edges. And it’s easier to cut out the linings after the first fitting of the product with the amendments made.
Sewing patterns are given on the pattern sheets in the magazine. You can cut them yourself. To do this, backtrack 3-5 cm from the neckline and smoothly draw an auxiliary line. Re-trim parts from the front and back patterns as separate parts. When cutting, the direction of the shared thread on the turning should always coincide with the direction of the shared thread of the workpiece. Tips are cut with allowances around the perimeter. To prevent stretching, duplicated with adhesive cushioning materials (in accordance with the recommendations for this material). Gasket materials are available at the Burda store. The neck section is reinforced with a strip of non-woven formbands also to prevent deformation and stretching.
So, proceed to processing.
Stitch the shoulder sections of the product and the shoulder sections on the edges. Do not neglect the sewing recommendations given in the magazine. Start / end the line exactly according to the marking (see arrows in the photo). Trimming allowances after grinding to 5–7 mm so that they do not coincide in width with the allowances for the shoulder seams of the product. Then, when superimposed on each other, they are thinner. Flatten the seam allowances. A multifunctional ironing pad is available at Burda. Trim the outer cuts of the grind. Pin the facing to the neck with the front side to the front side of the product. Schedule.
The rule: Scour from the side of the main product, sew from the side of the grinder!
Sew it down. Cut the seam allowances close to the stitch in steps! to reduce the thickness of the allowance (see arrows in the photo). In the rounding sections, cut, 2 mm short of the seam line.



If the neck does not need to be cut off according to the model, turn the grind up, iron the grind allowance. In this case, wrinkles should not form. It is most convenient to iron on a special pad for ironing or on the edge of the ironing board.

Then grind the grind to the seam allowances next to the grind seam.

Turn the grind to the wrong side, to its rightful place, sweep it with a slight roll in the direction of the grind, fasten the shoulder seams of the groove to the shoulder seams of the product - they should perfectly match. You can perform this operation on a machine, you can manually, most importantly - carefully.
And the final stage of the WTO is wet-heat treatment.With this it is important not to overdo it, otherwise all the work can be "nullified" by lasses and creases. Follow the recommendations in accordance with the types of material, use ironers and a special nozzle on the sole of the iron. Read more about the nuances of the WTO in the corresponding master classes of our site.
I hope that after such a simple MK, beginners will no longer be afraid of this type of neck treatment. Good luck